Formulated for surfaces finished with Waterlox Original specially processed Tung Oil products (as well as other finishes not affected by water). The slightly acidic pH will not damage the gloss or film of most finishes and is effective at neutralizing harsh cleaner residues left behind from other cleaners. Contains optical brighteners to enhance the beauty of wood surfaces when dry. Will dissolve all ice melt and hard water films, and never leave a soap haze.
Instructions for Use
For General Cleaning
AskthePainter likes the “clean and buff” method for regular cleaning as opposed to frequent mopping. Sweep all areas with vacuum and brush before applying cleaner Dilute 1-2 ounces of Waterlox Concentrate per gallon of warm water. This solution is best applied by misting spray on the surface of the wood, and using a cotton bonnet , towel, or micro fiber cloth on a mop frame to remove soils. Mist on cleaner to loosen dirt and film, then scrub and remove with mop or cloth, then buff with a separate bonnet or cloth, or simply allow to dry. No rinsing is required, and there is no residue.
For General Cleaning: Dilute 1-2 ounces of concentrate per gallon of warm water.
For Heavy Duty Cleaning: Dilute 2-4 ounces of concentrate per gallon of warm water.
The cap is 1/2 oz.
Dip mop into solution and wring out thoroughly. Mop floor in usual fashion re-soaking mop and wringing regularly If solution in bucket becomes dirty, discard and make up fresh solution. Rinsing is not required after use.
For other finished surfaces, follow the directions as listed above using a more appropriate applicator (i.e. sponge, washcloth, etc.).